Interested to Buy Any Domain ? << Click Here >> for more details...
Why the earth terminal pin is larger than phase and neutral
in three pin plug top>
- 8 Answers
- 15608 Views
- TVS, I also Faced
- E-Mail Answers
Answer Posted / pandu
some times the variation in supply voltage the load takes
high current to overcome this problem the earth terminal is
placed
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
How many capacitors using in LT panel as per Govt rules?
How can we checked Killo Watts of Motor & Alternator?
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
What are the advantages and disadvantages of open loop control system?
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
please send me latest & previous years question papers for IOCL Technical level questions
i have applied for the post of RRB section engineering chennai board please send me previou papers and solved answer. my mail id jagarapusrinivas@gmail.com
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
what clearance required for 4.5 mva dry type transformer?
Explain the different methods used in the choice of rotor slots for reduction of harmonic torques in an induction motor.
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
how to calculate the settings for shaft ct protn in hydro generators
During Testing of Maintenance Free Earthing, How deep should be the Spikes of Earth Test Meter should be inserted in the soil(one spike is 15 Meter & Other spike is 30 Mtrs away from the Main Earth Electrode. Because, recently, we observed that when spike is inserted 3-4 Inch in the earth- results are better, If spike is inserted 1 feet deep than results are increasing.
