Interested to Buy Any Domain ? << Click Here >> for more details...
what is bus coupler? and how many type? which one is big
advantage ?
- 2 Answers
- 11106 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / rsbangra
as per question bus coupler is couple two bus systems .
as otherways if two sourse of supply at same voltage same
frequency and and same phase sequence we can couple in
running and off condition of one source.
advantage
we can parralle two lines by bus coupler
we shift load one bus to other bus.
we can charge both bus by one sourse in case of one sourse
failure.
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
How can we measure earthing resistance test (Earth meggar) of Transformer neutral pit while in live condition?.
define the non synchoronism of synchoronous machine in general g or m??
can anyone explain 11kV 3core cable megger,hi pot test procedure with connection details?
When lag/lead/lag-lead compensation is employed?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
why does make gain margin and phase margin on same plot.?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
When the relative speed between the magnetic fields of stator and rotor does is zero under steady state operation?
what is ground fault in ACB?
What are the commonly used schemes for the bus zone protection?
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
why effective resistance should be more than static resistance in transmission line?
How to calculate MCB Breaking capacity.
What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
