What is the d/f between DOL & star delta starter & automatic
star delta starter?
- 23 Answers
- 157988 Views
- ACC, Dalkia, Engineering, Indeco, NINL, Novotel, RMH Control Systems, Wipro, I also Faced
- E-Mail Answers
Answer Posted / honey
in induction motor the torque is propotional to squre of
supply voltage in case of dol the motor directly connected
to supply so torque is more while in star delta the motor
is firstly connected to star hence voltage is reduced
torque will be less and when motor reaches its 80% of speed
it connects with delta with the help of timer then full
voltage is supplied hence less rating motor should be
started with dol but for high rating it should be with star
delta
| Is This Answer Correct ? | 58 Yes | 8 No |
Post New Answer View All Answers
What is inductance?
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
What is a system?
How many VSC based HVDC are there in India and the world
what is kvarh? Please define it With calculation General motors ?
What is the comparison of PILC and XLPE cable
What is the basic principle of welding process?
1600kva capacity Transformers how the bucholz relay,Oil temperature,winding,surge relay relays setting are to be done
the winding of Generator and Motor is star or in delta ? and why
How to design pavement quality concrete by using C.R.C.P Method
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
How does the slip regulator works as a startor
what is the main parts of transformer? how it is functioning? pls giv the ans briefly.
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
