Answer Posted / gobinath
DCS Means Distributed control system. This is working as a
master control system of full entire plant. its communicate
with all node control system (field Sub control PLC's and
control & execute the all closed loop process.
DCS -------- PLC 01
|---- PLC 02
|---- PLC 03
Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
How to Calibrate Coriolis Flow transmitter in field
what should he know if he is an assitent engineer instrumentation in cement industries of experience of 10 - 15 year.
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
I need to know steps to Calibration Valve Guard......
types of cable..? Use of every types of cable..?
Differentiate between ultrasonic flowmeter and radar type flow meter
can we copy the software from a transmitter using hht(hart 275) ?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
how many types of spped sensors n vibration sensors?their basic principle n connection?
What do you know about gail?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
What is the use of temprature compensation?
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?