How to calculate meter constant @ HT yard
- 5 Answers
- 10135 Views
- Juniper Networks, I also Faced
- E-Mail Answers
Answer Posted / msk92510@gmail.com
By taking the CT ratio we can calculate the meter constant
u sand this answer not sufficient me pls give me example
for this issue
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
various transmission tower like .,D tower ,K.C.O tower ,C.C.O tower,K.C.R tower ,C.C.R tower ,H.C.O tower in different tons.
With a phasor diagram show the effect of increasing the field current of a generator supplying a constant real power and connected to a grid system.
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
What is the pro & con of having 11kv & 33kv incoming, and what is the adv & disadv. of converting from 11kv to 33kv.
WHAT IS THE FUNCTION OF SHORT CIRCUIT MAINTENANCE CT
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
why fractional pitch winding generally used in alternators?
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
How to calculate the efficiency of Turbo Generator(Alternator) in general....?
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
How can find thermal state value in relay for calculate thermal overload.
Has someone here done a sizing for a generator (3 phase), its for a pumping station. If you have an example for standby/duty and both running (I) star delta (ii) Soft Starter.
How to measure the earth resistance value in a concrete pavement(flood light area)?
how we calculate torque ? how we improve it ?where torque will either motor or generator ?
