1)What will you do if main incomer VCB fail in your site ?
Answer Posted / sskumar
Hai everybody,
Good and thanks to all of you for giving a ideas.But here
we should discuss only Technical matters not for
management.
So coming to the point, first we should cut off the
incoming supply to the VCB, how? first we should open the
AB switch, then automatically the supply wont come to VCB.
Then remove the VCB and rectify it.
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Difference between ac parallel circuit and ac series circuit?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
What is reactive power and where it is used.
what is the relative size of single and three phase?
explain the mode of metal iranafer in Co,welding
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
What is different bewteen low or high impedance busbar protection scheme
Formulae for calculating the transmission line losses for different voltage levels
How to calulate Locked rotor amper(LRA) for compressor type motors?
What is process of anneling transformer core
What is marx circuit?
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
what is plunger and what's the use of it in motor alignment?
What is cathode ray oscilloscope (cro)?
What is the difference between DOL starter and star delta starter