What is the ratio of lenth divergent cone & convergent cone
in venturimeter.
Answer Posted / karthick
the length of the convergent is always kept lower compared
to divergent.the diameter of the throat should be 1/3 or
3/4 of pipe diameter and divergent length shd be 0.7*d
d-->dia of throat
the length of the convergent should be less than 0.7*d with
subtended angle of around 20 deg
Is This Answer Correct ? | 30 Yes | 23 No |
Post New Answer View All Answers
Properties of F.O. the cause damage on auxiliary boiler.
what are the different types of screws?
What is control volume system?
What are the basis on which the best material for sliding contact bearings manufacturing?
Find the greatest and smallest number among the given 5 numbers without using ‘>’ or ‘<’ operators
What is a liquid flooding in refrigeration system?
What is the purpose of ventilation in the battery room?
What is meant by indirect contact heat exchanger?
i require technical question paper which has been asked in last railway recruitment board exam for the post of junior engr.
Sir, I'm P.Ravi Kumar want to previous mechanical Question Papers for rrb exam
Why PWHT IS NOT DONE TO STAINLESS STEEL MATERIAL?
a three phase squirrel cage induction motor runs slow? list all possible reasons for such fault.
How to prevent back fire of boiler?
Where do you work in engineering company?
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.