Any one Give me formula for to increse the power factor,
0.8 to 0.95, How much the KVAr Required
Answer Posted / sonam sherpa
in above formual P.F- Capacitor rating in Kvar
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is reactive power and where it is used.
What is phase cross over frequency?
What is the restart inhabit setting in ABB spam150c relay (Motor protection relay)
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
how the inner and outer body is separated in aircrafts?
What is core CT & it's function?
What is different between resistance grounding system and resistance earthing system?
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
what are the installation procedure of high voltage power transformer,CT,CB&PT?
gas turbine genrator reactances
What is steady state response?
how we explain parallel paths armature winding?
what does vector group Dyn11 tell us? also tell me how will u differentiate between phase lead and phase lag thru this vector group
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?