In HT overhead line why should provide top conducter which
is not connected whith insulater..?
Answer Posted / ajit
It is generally used to protect the conductor from direct
stroke of lightening
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the drawback of static coefficients?
Single line digram for 11 kV to distribution use go,la and do
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
What should be the height of basement according to NBCC code?
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
How shall i select the value of capacitor or inductor in a system?
A TRANSFORMER 440/400V,DELTA/STAR CONNECTED.THE NEUTRAL CONNECTED WITH GROUND CABLE THAT IS DIRECTLY CONNECTED TO THE PANEL,FROM PANEL IT IS CONNECTED EARTH PIT.IS IT RIGHT? IF IT IS RIGHT LEAKAGE CURRENT AFFECTED.SECONDATY IS PROTECTED WITH EARTH LEAKAGE RELAY.
how to design the heater in temperature control unit to heat 50KL of water?
How efficiency of thermal plant can be improved?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
How many types of circuit loads are there in a common electrical circuit?
What is the difference between line drop and percentage line drop?
Please tell me in DETAIL about the following 3 types of fuses or recommend me a good power system protection book or a website link ? 1.Dropout Fuse 2.Striker Fuse 3.Empulsive fuse (not sure if its impulsive or explosion fuse , sorry)
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
sir i used 3 hp of motor for spraying pump, other home light and other home items which size of allminium pvc wire ix used