Interested to Buy Any Domain ? << Click Here >> for more details...
What is the standard height for stancion supports? and what
is the standard mounting height for different transmitters?
- 11 Answers
- 25451 Views
- Samsung, I also Faced
- E-Mail Answers
Answer Posted / raju b
Height of stanction 1.2 to 1.5 mtrs from the centre of the
instrument installed.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
If P will increase then what will happen with PID?
please tel me the calibration of pneumatic controler.
What is first echo & echo window in radar type level transmitter?
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
which type inter lock use in petrochemical refinery,and oil & gas?
Give Detail information about plc,dcs,and scada system?
How to fix back the valve actuator stem
describe flow nozzel principle?
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
