Interested to Buy Any Domain ? << Click Here >> for more details...
1)Why Bearing used in Motor and pumps.
2) Why Mechanical seal used in Pumps.
- 16 Answers
- 37263 Views
- Biocon, Exxon Mobil, I also Faced
- E-Mail Answers
Answer Posted / puja tulsiani
bearings: help in expansion and contraction balance in
pumps, for proper functioning during climatic change.
mechanical seal is less harmful, no use of electrical one
so as to avoid pump material damage
| Is This Answer Correct ? | 2 Yes | 15 No |
Post New Answer View All Answers
How can the reaction of support of a frame be evaluated?
What do you mean by the term thread size please explain what does 0.125 inch stand for in 0.125 inch npt thread?
Why do you want to leave your last job?
What is allotrope ? In what forms of cubic pattern, iron exists ?
What is the use of white metal?
engine so2 farmula
What is torque converter?
What do you mean by annealing?
thermal engg
For which parts the wahl factor and lewis form factor used ?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
Why preferred Production than Drilling?
Why rate of condensation is higher on a polished surface compared to rusty surface ?
I am a mechanical student.And have cleared the written for NTPC. Please suggest what and how to prepare for the interview.i have got only 2-3 weeks in hand.
what is the exact heat treatment cycle of IS 4522 Gr6 to get the required properties?
