how to calculate the size of cable for 100 kva load,?can
somebody tell me with a formula
- 7 Answers
- 57389 Views
- Havells, I also Faced
- E-Mail Answers
Answer Posted / manoj patel
From KVA , You get value of Amp.
By using standard cable catloge (size versis capacity)
you can find cable size.
That is only way to find cable size.From my point of
view there is no standard formula for that.
| Is This Answer Correct ? | 7 Yes | 11 No |
Post New Answer View All Answers
distribution transformer de-rating formula on over limit iron losses
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
Show the schematic arrangement of diesel power station layout and give its principle of operation.
Hi,I am working in abroad for more than 3 years in a company operating with 11kv and 6.4 MW power. I need c licence in India,can I? some other says only i can get if i work for 2 years in india only! anybody kindly clarify by doubt.Thanks
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
. What is Electrical Life & Mechanical Life of Circuit Breaker? 2. What is Electrial Life & Mechanical Life of Magnetic Contactor? 3. What is RCD, RCCB & RCBO? 4. What is the Between defferance of RCD, RCCB & RCBO?
how electical engineer is related to apsrtc (general) post? if they ask a question in interview as why did u choose this job what shd be answer
Explain few advantages of electric traction system?
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
Can a generator runs after getting 1st stator earth fault.
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
If two Transformers are connected in parallel having impedance of 50KA in both transformers will the impedance increase or decrease after connecting transformers in parallel?
What are the material used for inductance coil?
Different types of relay fault which phase sequence??
What is the difference between earthing,ground&nutral?
