DG B-check,C-Check,D-check is depending upon the running
hrs.If the running hrs is not reached as mentioned.How to
conduct the DG checks.
Answer Posted / baskaran.r
the checks are depend on the running hrs. if it is not
reached means engine is not running ok.you can wait till the
running hrs reached. if the stoppage is long you can go
according preservation requirement by the manufacturars
recomendation
| Is This Answer Correct ? | 43 Yes | 15 No |
Post New Answer View All Answers
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
ult of expression 'document.FrmQF.myem
3phase motor can be used as a Prime mover for alternator.
list the advantages of RCCB over other circuit breakers?
What is the formula to calculate the rating of a three phase miniature circuit breaker
Draw the single line diagram of the power station?
what is meant by re-rolling motor? how it differs from standard motor?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
How to measure the earth resistance value in a concrete pavement(flood light area)?
What are the different types of hydro schemes?
What id difference between power and energy?
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
what is the difference b/w ATS and HTS?
Is Transol transformer oil comparable to nynas nytro libra?