Write out a config to permit only the below MAC address
to pass traffic through a port on your switch.
mac-address 0005.1b00.5b58
Answer Posted / shahin
Switch(config)#interface FastEthernet0/12
Switch(config-if)#switchport mode access
Switch(config-if)#switchport port-security
Switch(config-if)#switchport port-security mac-address sticky
Switch(config-if)#switchport port-security mac-address
0005.1b00.5b58
Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
Why do you use ‘service password encryption’?
Can you explain static and dynamic tunnels?
When ip confliction accord in subnet which ip assigned automatically and what it called?
What is the difference between communication and transmission?
Can you give an overview of various components in IPSec?
What is a network subnet?
What is Phase od VPN in site to site and what information you will require to configure a SITE to SITE VPN
Define class full protocol?
Explain what is route poisoning?
What are the advantages of lan switching?
What are partial updates?
What does routing mean?
What are packets?
How many hope count rip or rip2 can send updates?
What is difference between routing and routed protocols?