how to check the 3ph capacitor is good or not.
Answer Posted / atul pradhan
Actually any capacitor is 1 PH for 3 ph you have to connect
it in star.
For checking -
1) Isolate capacitor from cap. bank check it's capacitonce
by capacitonce meter.
2) Take IR value by megger
3) Given 1 ph supply to cap. unit as per kvar rating,
adjust supply voltage by dimmer if required.
4) Noted all this reading & check with previous ones.
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
why the NGR (neutral grounding resistor) always OFF during DG off?
what is the maximum temperature rating of a thhn insulated conductor?
single phase power supply give to separate one steel coup with water, what reaction create
how to carry out Magnetizing Current Test on Distribution transformer and what purpose we are doing this test. why transformer rating in always in KVA ? what ispositive, negative, zero sequence impedence? How ElCB tripping if Neutral touch with ground Why AC & DC capacitor are use in UPS ? why motor rating in KW? how to syncronize two dg sets
write a c++ code that receives an integer number and display the sum of the number and its revers integer?
What is the meaning of loop in transformer
what is effect of length of air gap on performance of dc motor and generator?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
why did youi choose this career?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
Control cables in S's will carry 1000v which is AC R DC? Pls answer meĀ
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
Anybody know how schematic diagram for reverse power relay? RPR for generator protection
what is the significance of tan&delta and how it performed in power transformer