What is the d/f between DOL & star delta starter & automatic
star delta starter?
- 23 Answers
- 158115 Views
- ACC, Dalkia, Engineering, Indeco, NINL, Novotel, RMH Control Systems, Wipro, I also Faced
- E-Mail Answers
Answer Posted / cool
Whenever you start a big heavy electric motor, you need to
start it slowly to prevent the rotor overheating and
drawing an enormous current. When the windings of a 3-phase
motor are connected in STAR the current is reduced to only
root three of the normal running current that is taken when
it is connected in DELTA.
| Is This Answer Correct ? | 141 Yes | 19 No |
Post New Answer View All Answers
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Main advantage of auto transformer over two windings transformer is that A it needs no cooling B it uses only one winding C core losses are reduced D it has simple construction
Why we use circular(Stepped) cross section in transformer core?
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
why you don not show protection and type of isolation in key single line diagram?
WE HAVE THE DC RECTIFIER 1500A, INPUT VOLTAGE IS 3 PHASE. HOW TO CALICULATE THE LOAD? 3 PHASE SIDE EITHER dC SIDE. PLEASE SUGGEST ME
How to calculate loses in transformer of 160 KVA ?
how to calculate slip ring induction motor stator and rotor currents??
What is the lockout relay
we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V
What are the weight of 800KV DA,DB and DC type tower ?
What is difference between Over Current & Earth Fault protection?
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
what is the relative size of single and three phase?
Could the power factor on electrical system can affect the registration of the kwhr meter or the CT/PT?
