What is the rating of HT SUBSTATION and LT SUBSTATION?
- 11 Answers
- 53204 Views
- NTPC, Sail, I also Faced
- E-Mail Answers
Answer Posted / ivan
Voltage rating at HT & LT varies from country to country..
LT normaly >> to domestic distribution network.. start from
11 KV to 415 V.
LT normaly the transmission lines 66 & above.
| Is This Answer Correct ? | 5 Yes | 12 No |
Post New Answer View All Answers
Why auxiliary transformers are not connected in parallel in primary stations?
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?
defult setting in p220 micom motor proction relay for 11kv,640kw,f.l.a.-40a,1440rpm ht motor?
Whether it is possible to measure energy at the input of rectifier transformer (12 pulse with very high odd harmonics)
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
What's the difference between non break power supply and non break non short break power supply
If short circuit ratio is high is it bad or good for a machine then tell the reason...
What is the Surge for 1.1 Phase Induction Motor(For Eg.1Hp) 2.3 Phase Induction Motor(For Eg.1Hp) 3.AirConditioner(For Eg 1Ton) 4.Refrigerator(For Eg 180Ltr or 160kW) 5.Induction Cooker 4. Ceiling Fan
what is the calculation formula for motor starting torque,running torque, running torque.
in my working site. momentary jerck in electrical supply ocurred frequently which cause of multiple losses in our electrical equipements. how can we protect our electrical machines and equipements in this situation.
how to electronic energy metter failed in electomagnectic fild passing in the metter and which thing to defect more on metter.
what is ramping rate of generator
