Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kk_london
Normally busducts are used in between secondary side of the
transformer to panel where the distance will be short and
current carrying capacity will be high the busbars used are
generally of greater cross sectional area than the cables,
and also once they are fixed it hardly requires any
maintenance except for tightness in cables you need to do
period check of IR.
| Is This Answer Correct ? | 47 Yes | 2 No |
Post New Answer View All Answers
When the relative speed between the magnetic fields of stator and rotor does is zero under steady state operation?
what will happen if frequency is below 50 hz?
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
What are the special cables required for explosion proof wiring?
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
What are the essential characteristics of signal flow graphs?
what is transistors comprised of?
Electrical Engineering
why we need to us lenz's law for synchornous motor
what are factors comes under relay setting (distance relay 7sa52) under OPEN DELTA VTs connection??
what is advertised hop count
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
