Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kk_london
ht means high tension voltage, ht voltage starts from 6.6kv
onwards to 11kv, 33kv, 66kv, 110kv, 220kv and so on
generally ht are used in transmission and distribtuion in
order to reduce the power loss i.e. when you send power at
high voltages current will be of small proportion and hence
decreasing the size of conductors and also the supporting
structures required to hold the conductors need not too
strong so over all a great amount of cost reduction can be
done by sending power at very high voltages and other than
transmission and distributing section ht voltages are used
for motors of greater capacity around 220kw, 315kw, 900kw.
And same priciple applies to motor as well and more over if
you go for lt voltages for the above range of motors the
insulation required for the stator and armature will be
more because at starting the motor takes 6 to 7 times the
full load current of motor.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
Q) Write VBscript code along with QTPscript code in QTP tool for below scenario 1. Launch yahoo site(i know) 2. Do loogin(i know) 3.Click inbox link(i know) 4.Go to every page of mail box and count no.of read mails and no.of unread mails(i know) 5.Store page numbers, read mail count and unread mail count in a new excel file sheet 6.Create 10 types of graphs on that data 7.Do logout and close site(i know) 8.Save new excel files with graph
How is operate breaker failure scheme in substation
why the check zone and main zone are used for Busbar Protn. scheem?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
what is the stear deltaprinceple?
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
What is polar plot?
What is meant by control system?
what kinds of Transformer oil grade is better for power transformer ?
How many types oil using in transformer ? How many letars using in transformer..?
Why we use circular(Stepped) cross section in transformer core?
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
Explain the operation of grid connected central solar inverter ?
What does the kvar means?
