Interested to Buy Any Domain ? << Click Here >> for more details...
Hoe to calculate body earthing conductor size ?
- 1 Answers
- 9805 Views
- IES, I also Faced
- E-Mail Answers
Answer Posted / aamod tripathi
The body earthing conductor sizing is done in india and
internationally by IEEE 80 :2000 standard and IS code 3043
These instruct the different formulae which are to be used
for calculation purpose generally it requires
1. fault current
2. time duration of the fault
3. a factor which is denoted by K and is dependent on the
material used for earthing.Table (1.D)(This takes into
account the ambient and operating temperature of the
material)
In case of a power house where many Transformers and the
switch gears are installed there we have to install
acompletee earthing grid which is like a square or
rectangular net of rods. the number of rods and ground rods.
The most important point in both the powerhouse earthing or
any other kind of earthing we have to keep in mind that the
earthing arrangement should have the resistance less than 1
ohm........ it is an essential conditon that must be
fulfilled.....
| Is This Answer Correct ? | 14 Yes | 5 No |
Post New Answer View All Answers
List the power rating of any 5 important electrical appliances used in houses.
Why efficiency of generator is higher than motor at a particular load?
Type of motor stater detail and working detail
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
what is auto re-closer?
Efficient electrical earthing in hard rock area
i have done diploma and btech in EE and live in Chandigarh so kindly help me how can i make my competency certificate in my area.
What is the basic rule for block diagram reduction technique?
explain the function of brush less dc motor?
How many double suspension hardware fittings are required on a double circuit transmission tower?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
Name of the relay of low lub oil presuure in DG sets
i want bhel placement paper for electrical if anybody having pl send to my id kavitha867@myway.com immediately
Why synchronous motor is used in power factor improvement,dc series in lift
I have iti elec, 1st aid, and 5 yrs experience in 7.5 mw power plant. Am i eligeble for 11kv license in telangana state..when, how to apply for that.?
