In a Circuit how the MCB and Fuse ratings are calculated.
And shall the fuse follws the MCB or it is otherwise?
- 16 Answers
- 87932 Views
- Emerson, HCL, Thirumalai Chemicals, I also Faced
- E-Mail Answers
Answer Posted / shaik
depending on the full load capacity ratings is calculated.
It is not necessary to connect MCB and fuse both,one is
enough.if u want to connect both then first fuse the MCB
| Is This Answer Correct ? | 11 Yes | 15 No |
Post New Answer View All Answers
how to select automotive wire by mathematical equation with given current, vlotage and resistance
how we can come to know that motor winding resistance which showing by DMM is right or wrong???is there any chart or something that we will compare & check???
What is tranformer differtial?
what is RFCT and Insulgard Relay & It's function?
any application of back emf
What is industrial plc
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
HAI SENT HPCL APTITUDE QUESTION PAPER, MY EMAIL ID IS angus_eee04@rediffmail.com,angus_eee04@yahoo.com
diff. between tension mode & speed mode
how to identify the cable quality and what is flame proof cable
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
Why increase in current leads to increase in conductor temperature?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Explain Energy and Power signals?
What is meant by derating factor?
