Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kumar
because ht motor starting current always high so that
motor connection should be star to delta for limiting the
starting current.the principle is that staring position
motor connection in star later it change to delta
| Is This Answer Correct ? | 19 Yes | 20 No |
Post New Answer View All Answers
What is meant by Load Encroachment in OHL Feeder Protection?
What is difference between start imitation and start interlock for 3 phase motor protection ?
what is v/f control in VFD?
What are the different circuits in thermal power plant?
how to check ac servo motor
when elecromagnatic waves are propogated in a wave guide?
who can measure the size of power cable?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
Power Factor Correction Panel (Manual & Automatic)
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
what is positive , negative & zero equivalent system resistance
Best way to measure the Soil resistance of rocky soil, three probe method and four probe method
Formulae for calculating the transmission line losses for different voltage levels
HOE WE CAN IMPROOVE BY USE OF CAPACITOR
