Do you know how to measure the earth resistance? if so
explain it
Answer Posted / rajshekhar jangnure
there are four terminals p1,c1,p2,c2 outof this earthing
electrode connected to p2 and p1 &p2 get shorted There are
three electrods which are 60 to 70 feet equal distant from
eachother along withearthing electrode whose earthresistant
tobecalculate .then set 10 oham range & connect all
electrodes as mentions above by 1.0sq mm wire & rotate the
handle with constant speed & note the
reading
Is This Answer Correct ? | 10 Yes | 18 No |
Post New Answer View All Answers
what is current check gurd relay?
Rules and standards of electrical control wiring ?
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
What are the criteria shall be considers for sizing Fuse and MCB? If the rated current is 10Amps what should be the fuse size / MCB Size?
What is the meaning of 40X8X2 busbar dimensions for carring load of 400 Amps
sir please tel me how calucalte kwh if home taken load 30ams how maney kwh taken per day.and 3phase motor 5hp per hars how maney load teken and how mach kwh and forward me to electrical table for calicalte kwh and kvr and kvah
What is VCB? where it is installed at SP. What is SP?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
What are chief characteristics of state-space method and its techniques ?
dg earth connect only in the amf panel or not why
Sir, I have applied for the of Assistant.engineer of NPDCL. please send me all AP TRANSCO AND JENCO solved papers of previous exams . I requested send me the papers to my id as soon as possible (rajanikanth_peddi@yahoo.co.in) (This is very urgent) Thank You,
specify the inbuilt protections in DG
Why do we use center tap transformer that used with portable tools
Define end float in a motor?
What does bode plots shows?