Interested to Buy Any Domain ? << Click Here >> for more details...
When a field input to plc is coming from 400 to 600 meters
and the input is in 24 V DC? So signal cable of which cross
section i should select for proper signal to plc?
- 5 Answers
- 12195 Views
- Exxon Mobil, I also Faced
- E-Mail Answers
Answer Posted / jayeshpateler
as per the 1cm3 core wire will be find also check the
current require then as per the current if it is higher
than you can carry but if current is low then you need to
use the repeater for that.
| Is This Answer Correct ? | 4 Yes | 5 No |
Post New Answer View All Answers
What is the difference between PLC and DDC?
How to calibrate the flow transmitter
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
What is the purpose of LO Overhead tank in turbines.
Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?
how to commission furnace ( water heater)
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
kindly sent some demo question and answer
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
Why plc require in analog input 4-20amp & 0-10 volt?
if my flow is 20000 m3/h than which range of DPT i have to use????
What is profibus?
How does your previous experience relate to the job you are applying for ?
what is interface level and how it is calibrate?
