Interested to Buy Any Domain ? << Click Here >> for more details...
During he starting up of the motor, the upstream's MCCB
(350A) always trips due to the UVT relay activated.
Can Star-delta starter use for a 20kW Motor (For a powder
mixer machine) cause voltage-dip in the supply line voltage?
If so, what are the recommended solution to
eliminate/reduce the transient voltage dip in the line
voltage?
- 4 Answers
- 6974 Views
- I also Faced
- E-Mail Answers
Answer Posted / piyush rana
You can check the length of the cable from the supply to
motor, I think It will be more so that due to line
resistance loss during starting the line voltage will go
down for the fraction of seconds.
please mention the connected load, transformer capacity,
volatge incoming etc for further clear answer.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How to calculate cable size by using load.?? Any formula...
Is there any specialised book to refer about fault level calculation both in MV and LV side??
Can u explain : what is supply for train (whether a,c or d.c ).I know that supply is 25000v a.c .But there is rumour that supply is D.C. And also explain how lights and fans inside the trains are working ,and what type of motors are used in trains whether D.C motors or induction motors .If d.c motor, how it gets supply.If traction motors are used then what are traction motors and its functions and how it differs from other motors and also explain about locomotive . y d.c series motor in train.train wheels r driven by D.C shunt motor ,at what voltage,and at what speed. please reply..............
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
1. Design a counter which counts 0, 4, 8, 2, 6, and repeats using: 1.a using JK flip flops 1.b using T flip flops 1.c using D flip flops
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
low frequency protection why recomend?
what is the significance of cabability curve of alternator
What is Traction? 1KVA Alternator, How much urrent taken?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
What is current & voltage ? Voltage perform at any load without current or not?
How to calculate the phase to phase clearness of HT /// LT bus bar?????
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
Why delta star trformers are used for lighting loads?
What are the advantages and disadvantages of negative feed back?
