how to calculate the steel for rcc slab?
plz tell me the formula for calculating the steel?
Answer Posted / k.srinivasa rao
for calculating the area of steel in rcc slabs,
ast = ( M ) / (.87*fy*(d-.42*xu))
where
M= moment corresponding to entire loads of span in one
meter length
fy= characteristic strength of steel
d= depth of slab
xu=lever arm depth depending upon the type of fy given
in Is:456-2000
Is This Answer Correct ? | 216 Yes | 72 No |
Post New Answer View All Answers
manhole height is 1500 mm and width of brickwork is 230 mm dia of manhole covering is 560 mm brick masonry 1:4 horizontal length is 1500 mm and plaster 12 mm thick on both side 1:3. how to estimate the quantity of brickwork with mortar cement and sand for manhole chamber.
what are the cube & Sylinder strength of concret M20,M25,M30,M35,M40,M60 ,M75,M10 ,M15
What are the main reasons for conducting pull-out tests for soil nails?
Can we use concrete of slump cone in cube casting in which we have already measured slump?
how much area can be platered by a mason for exterior
Hi.. Can i get hel in finding HPCL previous year question paper? plz help me in finding thiss..
how gradation of aggregates effect on slump of fresh concrete?
How to calculate the force on a column of three story building. What should be the base concrete height?.
20 mpa what is the quantity of cement sand and aggregate in one cubic meter of pcc non rainforcement concreate kindly answer including formaula thanks
Determine the production capacity of a treatment plant for a city of 1,250,000 population. Assume the specific consumption per capita of 15ol/c/d, non-domestic water use of 30,000,000 m³/year, and UFW of 12%.
IN Compression testing machine 1division =10KN ,then what is compressive strength of 100*100 mm cubes at a load of 320 KN
how much is the maximum compressive strength of soil cement and soil-cement-microsilica .
to draw bm diagrams for portal frames under different loadings//
what is the difference between prime coat and tack coat in road construction
What is the snap size in civil and how can we create it?