Is a cross-over cable needed to connect the EZ serial
switch to another hub or some type of device?
- 6 Answers
- 9139 Views
- I also Faced
- E-Mail Answers
Answer Posted / dhirendra ukey
Yes, it is necessary to use cross-over cable to connect to
same type of devices, and here EZ serial switch and hub are
of the same type.
| Is This Answer Correct ? | 19 Yes | 2 No |
Post New Answer View All Answers
How to filter out the default route from outgoing bgp advertisements?
What are the advantages of using PPPoE or PPPoATM?
Differentiate broadband router and ethernet switch?
What is the difference between routers, switches and hubs?
Is analog and digital voice supported?
Explain what is routing table?
How does the WIC support AAL2?
Where do the Cisco 1700, 2600, and 3600 with ADSL WIC fit into the Cisco product line?
How can I utilize AAL2 support?
How many WICS can be installed in a Cisco 2600/3600?
What does the ADSL WIC enable?
What Cisco IOS Release is required?
What is DSL?
What market segment does the Cisco 2600/3600 Series target with the ADSL WIC?
Give the ip address of the switch?
