Is a cross-over cable needed to connect the EZ serial
switch to another hub or some type of device?
- 6 Answers
- 11247 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / dhirendra ukey
Yes, it is necessary to use cross-over cable to connect to
same type of devices, and here EZ serial switch and hub are
of the same type.
| Is This Answer Correct ? | 19 Yes | 2 No |
Answer / munna
cross over cable are connect to same type of devices likes
hub to hub,or pc to pc
| Is This Answer Correct ? | 6 Yes | 1 No |
Answer / s.m.feroz ahmed
Hi,
No, as the 2 devices are dissimilar devices we require
Straight Cabling as switch and hub are 2 different devices
we require straight cabling to connect.
If 2 devices are similar then one requires a Crossover
cabling.
| Is This Answer Correct ? | 2 Yes | 2 No |
Answer / s.m.feroz ahmed
Hi,
Cross Cabling is used to connect to similar devices in a
network.Here Cross-over cable is used to connect EZ Serial
Switch to Same type of device which is similar and not to
hub.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / mohammad shamshad
it is necessary to use cross-over cable to connect to
same type of devices, and here EZ serial switch and hub are
of the same type.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / amuthan
yes,we need cross over cable to connect EZ serial switch to another hub but we need straight through cable to connect other type of device. we also used straight through to connect EZ serial switch and hub , this type also going to recognize the connection..
| Is This Answer Correct ? | 0 Yes | 0 No |
Does the WIC require a splitter?
Is this WIC physically the same WIC that has been available on the Cisco 1700 series for some time?
Is dying gasp supported?
How to filter out the default route from outgoing bgp advertisements?
What are the reasons to choose ADSL for business?
What is the difference between switches and hubs?
Is analog and digital voice supported?
Most networks employ devices for routing services. Routers work at which OSI layers?
How can I utilize AAL2 support?
Which is a type of hub that forwards packets to an appropriate port based on the packet's address?
What are the differences between DMT and G.Lite?
Routers are used in which layers?
Telecom Routers Switches 
