Transformer's core is made up of which material and why so?
- 10 Answers
- 29096 Views
- ABB, NTPC, I also Faced
- E-Mail Answers
Answer Posted / swapnil
Transformers for use at power or audio frequencies
typically have cores made of high permeability silicon
steel. The steel has a permeability many times that of free
space, and the core thus serves to greatly reduce the
magnetising current .
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
PLZ sent the previous year question paper for GET in NHPC on my EMail id ppshanker@gmail.com
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
What consists of 2 or more thermocouples to be connented series?
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
can we synchronize star system generators with delta system transmission line ? and how ?
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
I am shobana from Chennai. I am having my personal interview on 19th Dec at Chennai.kindly mail me the questions to mail id shobana.shanthi@gmail.com
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
why dc is used in control circuit for mv & hv switchgear instead of ac
what is the carona effects meaning in HT line transmmission system
What the difference between ac and dc inductor an capacitor
