how to check the 3ph capacitor is good or not.
- 14 Answers
- 54870 Views
- MacLellan, Yash Technologies, I also Faced
- E-Mail Answers
Answer Posted / lokesh kumar
First charge the capacitor. After charging use multimeter.
If the multimeter shows any deflection, then the capacitor
is in good condition.
We can also check by connecting the two terminals, but this
is not the proper and safety way.
| Is This Answer Correct ? | 5 Yes | 6 No |
Post New Answer View All Answers
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
Battery is a voltage source? give one example of current source and why?
whats the application of voltage regulation? and whats the voltage regulation's device?
What is the difference between rulling span and wind span of of an Over Head Transmission Line?
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
suri transmission
what does mean of RCT and STR in diffrential CT?
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
Can a generator runs after getting 1st stator earth fault.
from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
What is the name of the winding to which supply is given?
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.
