what is the difference between cable routing and scheduling?
Answer Posted / suni
Victorvgp good answer
Do u know when connector is used both end how cabel is
selected.
if U KNOW MAIL to suni_sa2003@yahoo.co.in
Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
Explain mechanical rotational system?
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
Where can i get practical knowledge of solar system?
Write a note on materials used as a fuse element.
from which subjects most of the technical que will b asked for hpcl(electrical).pls help me
in electrical control panel. how can i choose the cable rating. (example - 11kw motor, 18-25A mpcb}
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
What is a differential amplifier?
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
what does mean of RCT and STR in diffrential CT?
design of IGBT firing circuit for 11KV