why earthing is not required on transformer prymary winding
side ???
Answer Posted / balu
If you take the case of Y/Delta step down t/f , it don't have neutral thats why no earthing req.
| Is This Answer Correct ? | 2 Yes | 16 No |
Post New Answer View All Answers
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
How does a transformer contribute towards the widespread popularity of ac system over dc?
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
Explain the fundamental difference between emf (electro motive force) and pd (potential difference) ?
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
How to calculate LT XLPE CABLE for 11 kv / 433 v , 1000 kva oil type transformer system?
what & how to check the lightning arrester
EXPLAIN METOD OF IMAGE OF TRANSMISSION LINE/ WHAT ARE ITS PRACTICAL APPLICATION?
What is called limb of a transformer?
percetans
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??