Interested to Buy Any Domain ? << Click Here >> for more details...
Can anybody explain Why starters are not used for motor
starting in industries?
- 9 Answers
- 11658 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanjeet
starer reduce starting current with adding the external
resistance with the armature in series ,because the
resistance of the armature is very less,so starting current
is very high .
I=V/R if r is less then curent is very high
to reduce the starting curent starter is used.
up to 5 hp motor dol starter is used
but in industries the rating of the motor is if higher
thane 5 hp then starter is not used
| Is This Answer Correct ? | 1 Yes | 9 No |
Post New Answer View All Answers
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
how to select energy meter? have any calculation?
Write the analogous electrical elements in force current analogy for the elements of mechanical translational system.
why we use 630mm single core cable for transformer secondary side and why two neutral cable
I need model question papers for RRB section engineer Chennai... Please send to my E-mail Id:- maitheerainbow@gmail.com
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What test must you do before powering up a circuit that you have been working on?
How to calculate impedance volt in Transformer?
How colour picturetube works & how many year it will works.
What is the criteria for selecting the voltage classes of an AC Induction Motor.The KW rating above/below which ht/lt selection is made may be provided in details.
what is the efficiency of thyristor
explain with diagram how to protect transformers and substations from over current with help of CT's?
Differentiate between voltage and current feedback in amplifiers?
