Interested to Buy Any Domain ? << Click Here >> for more details...
Why a starter is used for a motor?
- 50 Answers
- 146723 Views
- L&T, Nilachal Polytechnic, I also Faced
- E-Mail Answers
Answer Posted / sanjeet swarnakar
to limit the starting current ,because the resistance of
armature is very less so starting current becomes four to
five times . so to save the motor starter is used
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
what are the different kind of cables used for transmissions?
What is reactive power and where it is used.
why motor range is available 22kv,30kv,37kv,45kv and so on? why motor range is not available 21kv,24,25,26,27kv and so on?
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
being an electrical engineer why you wanna come into software i have an very good academics what answer i have to give
if negative of DC supply used and positive is grounded through EGB, and if ELCB used in the system then is it sense the positive volatge and get tripped is it possible?
why are the maintaine power factor and how can this control and this is how work.
How to select transmission line type (i.e. 11kv or 33kv) for new established industries
How grounding is different than earthings?
what parameters are should nessary for control technic dc drive(in rolling mills)?
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
how commomn gate triggering is given for TRIAC ? other thyristor wont be efffected?
boiler is running in rankine cycle and deisel generator is....?
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
any application of back emf
