Answer Posted / suresh kumar

Switch off the all capacitor bank except one whcih u want
to check, if pf value decreasing the same time then its not
good,other capacitor can be check as same procedure.
Don't short cerkit.....
It will be dangerious.........

What are the factors influence the choice of an electrc drive?

2076

---

what is meant by brushed alternator & its working principle ?

1922

---

HOW TO SET THE EARTH FAULT SETTINGS IN ACB????????????

2161

---

Load break swicth maintenance procedure.

1761

---

What is the magnetic field (coil DC ) of Turbo Expander?

2063

---

Which contains in POLE ASSEMBLY of a 11KV Kirloskar-make SF6 (Model No-FP620A12)? Will u clarify with drawing?

2164

---

What is warm / cold start of HT motors. How many warm start & cold start are possible in a day?

2047

---

I want to replace the 3 KW DC motor with AC motor so what should be the rating of AC motor? Details Of DC motor to be changed with AC are - Kw - 3, Vf - 310, If - 0.15, Va - 400, Ia - 13, RPM - 2400

1811

---

What happen when change order of CT in GIS feeder?

1648

---

WHY IN AC DRIVES,INPUT PHASE CURRENT SHOW UNBALANCE?

2290

---

1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

2026

---

what is the Transformer Impedence?How can calculate?

2090

---

how meger function

2881

---

what are safety measures in /control in diesal engine/ explain them?

1786

---

What do you mean by a current transformer?

1088

---