What is the total bandwidth of all channels on a BRI circuit?
A. 56 kps
B. 64 kps
C. 112 kps
D. 128 kps
E. 144. kps
- 5 Answers
- 11829 Views
- Infosys, I also Faced
- E-Mail Answers
Answer Posted / guest
144. kps
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
What is the difference between full duplex and half duplex?
which points are eliminated by the DBSCAN algorithm?
Which command we give for live view of remote site routers?
Explain the draw back of ospf protocol?
Which mode we can't skip when we come back from interface mode?
What is the default behavior of access-list?
Tell me how many hop counts are by default and how much you can increase in eigrp protocol?
Which LAN switching method is used in CISCO Catalyst 5000?
What is protocol data unit in ccna?
What are the conversion steps of data encapsulation?
Explain which layer are called upper layer?
Suppose we are having two Switches i.e. Switch1 & Switch2 Port1 of Switch1 is Connected to Uplink and switch2 is also connected to switch1? So 1>Is there is any loop? 2>How we come to know that there is a loop created? 3>If we add Switch3 to switch2 then there is a possibility of loop Creation?
What is the difference between static ip addressing and dynamic ip addressing?
which algorithm as defined by the transform set is used for providing data confidentiality when connected to tyre?
What route entry will be assigned to dead or invalid route in case of RIP?
