Interested to Buy Any Domain ? << Click Here >> for more details...
In step down transformer (415/200V),mistakenly secondary
side is connected to 415V for some hours, what would be
result of this condition?
- 19 Answers
- 29349 Views
- Essar, GAIL, Vizag Steel, I also Faced
- E-Mail Answers
Answer Posted / deepakeee
winding will burn
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
How is the gain affected by the introduction of feedback in a control system.
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
what will be project cost for 100 kv transformer connection under oyt scheme.
What products have you designed which have entered high volume production?
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
xfhnchncv?
What is the physical significant of power factor?
what is the min and max ohmic resistance for the earthing rod installed for lighting poles for street light network
Explain Continuous and Discrete signals?
how can i get the formula to find out the cable size if i know the load of main fuse protection.
Define damping ratio.
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
