Interested to Buy Any Domain ? << Click Here >> for more details...
what is inrush current in transformer?
- 17 Answers
- 42586 Views
- Bhel, Essar, GMR, I also Faced
- E-Mail Answers
Answer Posted / amit dubey
When we charge the Trafo, flux will get generated there,
but when we make get it isolated some flux will remain
there.Again while we charge the trafo,remaining flux will
oppose the present flux hence high current will get
generated, which is very dangerous for trafo. The current
produced as n above condition is called Inrush Current,
which is flowing for very minor time ()
| Is This Answer Correct ? | 8 Yes | 8 No |
Post New Answer View All Answers
what is the difference between dry and wet type of 132kV terminations. which one is durable
What is a fuse? How does it work? What are materials used?
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
relation between power station capacity and voltage level?
What is cathode ray oscilloscope (cro)?
what should be the no load current for 3 phase ac motors ranging from 5 kw to 1000kw?
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
what purose of the double circuit transmission line phase of the line phase changed for circuit-1 for Circuit-2 R-Y-B B-Y-R
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
What will happen if the d.c. Machine is operated below rated speed?
I want the details about BHEL company examination.Can anyone able to help me please.
what are the parameters plays a major role in Potential transformer Burden calculation??
Why hydropower is called renewable source of energy?
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
