Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sa
First, take a clean wire loop of Platinum or nickel-
chromium . They may be cleaned by dipping in hydrochloric
or nitric acid, followed by rinsing with distilled or
deionized water.
Test the cleanliness of the loop by inserting it into a
bunsen burner flame. If a burst of color is produced, the
loop was not sufficiently clean.
Ideally, a separate loop is used for each sample to be
tested, but a loop may be carefully cleaned between tests.
The clean loop is dipped in either a powder or solution of
an ionic (metal) salt. The loop with sample is placed in
the clear or blue part of the flame and the resulting color
is observed.Na+ plus gives dazzling golden yellow flame,Ka+
gives crimson red & when look through blue glass gives
purple colour. Ba salt gives apple green colour , Ca++
gives brick red colour,etc
In this way Flame test is done.
| Is This Answer Correct ? | 18 Yes | 3 No |
Post New Answer View All Answers
what is partion and column chromatography
what type of question will ask in the interview of lab chemist.
how a particular wavelength can be different for a particular compund while analysing by uv and by HPLC.
is it necessary to do HPLC calibration at wavelength 315nm if we are doing analysis at this wavelangth
what is different when impergnated silica plates are used in separation of azo dyes using column chromatography?
why we are using benzene, anyline in acetic anhdride assay titration method?
in which situation require to take incident in validation?
If change in specification which parameter require to do for validation? if change in chromtographic condition then which parameter? if api change then which parameter? if change composition then which parameter? if old method not work out then whicj parameter? if additional one impurity added then which parameter of validation require to do on above each conditions? elaborate separately
How to fix the sample conc. in Related substances test by HPLC?
Identify problem faced when mass spectroscopy is used with HPLC system ?
Why do we use KMnO4 in the test of control of obsorbance ? and why do we take specific quantity i.e 57-63mg?
if your product is soluble in 0.1n hcl and water then which you choose as media from these 2 media?
UV and PDA detector, which have less signal to noise ratio?
which are the diffrent batches in the pharmaceuticals?
