WHAT IS BASICS TO SELECTION OF 11 kv Trasformer, send any
calculation sheet for selection of transformer
Answer Posted / prabhu gnanasekaran
11 KV transformer or anyother transformer the calculation
of the transformer is done only as per the loads connected
in it(Continious load,stand by load and Auxillary load). No
of motors connected to it,KW rating of the mator, Total
line current of all motors.
If it is 11 KV the your primary side of the transformer is
11 KV thats all. Due to this 11 KV the line current
calcultation will change in the factor of system voltage
level in Line current calculation of the motor.
Is This Answer Correct ? | 8 Yes | 16 No |
Post New Answer View All Answers
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
explain safety measures in alternator?
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
What is the Current equation in series RLC circuits.
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
condition Autotrip facia come on control panel of electrical transmission line?
Enlist four components of electrive drives.
Classify driling machines.
How seriving & testing of the HT & LT breakers are done. What are the standard Ir values on which we can come to know the test is passed or failed?
Pl. brief about break-down maintenance of machine tool.
i have 90kw motor.so i choose connect cable .please what is parameter checked so please give to formula
What is meant by stator?
If we are given a 10 amp cable type and asked to calculate the number of cores used and the thickness of the cable, how do we do it?? please help...urgent!! i hope the question is clear enough!!
why the neutral point in connnection oscillates?