Interested to Buy Any Domain ? << Click Here >> for more details...
What will happen if 230V DC motor connected to 230V AC
Supply?
- 15 Answers
- 63550 Views
- Ashok Leyland, BOC, JSW, ONGC, RRB, TRB, I also Faced
- E-Mail Answers
Answer Posted / rajesh tokalapudi
when a dc motor is connected to a ac supply it will run
with reduced efficiency.in case of ac reactance will comes
into picture.so,increased losses due to inductance.and
there is sparking at brushes.motor will run with reduced
speed.
| Is This Answer Correct ? | 83 Yes | 22 No |
Post New Answer View All Answers
what are the interview question asked in wind mill about electrical
Control cables in S's will carry 1000v which is AC R DC? Pls answer me
What is the function of attenuator in cro?
What are the material used for resistor?
CPC cable .PVC \1C....I want to get sure that type is flexible indoor or to be install on trench. please advice .thanx :)
What is primary and backup protection?
hi, i finished b.tech eee in 2008, im worked in dg sets mfg company , now i left job in 6months back, now again i want get job core side, how can i get? is there any couses we have learn to get better oppurtunity? /
what is the difference between electrical and electronic choke?
what is a power factor?
What are the significant parts of dc generator?
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
What is the bundle conductor?
What are the advantages & disadvantages of a group electrive drive?
how unidirectional torque is produced in DC motor?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
