i want pattern of ONGC Written examination
Answer Posted / vishal f. yadav
ONGC exam pattern consists of mainly two section.
(1) Section 1,General awarness common to all disciplines.
(2) Section 2,Subject specialisation,,,e.g. Mechanical
engg,civil engineering,finance,HR,marketig etc.
generelly there is no negetavie marking.
Once witten exam cleared one has to appeared for PI based
on your resume,work experience,subject specialization
knowledge etc....
Wish u a bright career!!!!!!
Is This Answer Correct ? | 40 Yes | 1 No |
Post New Answer View All Answers
What is a common failure mechanism for above ground atmospheric storage tanks?
could any one plzz give me the placement tech papers taken by iocl,and bpcl in chemical stream..... my id is.... mishra.gaurang@gmail.com
can anyone send me the written test paper of Indian oil corporation ltd. My email id is pratuljakhmola@yahoo.com
When an expansion is joint needed on the shell side of a shell and tube heat exchanger?
Explain what are the criteria involved in choosing mass balances for components?
X is a solid having a white colour at room temperature. It has a density about 2g/cc. Although it has melting point near 325 degree Celsius, its properties start degrading above 260 degree Celsius. The coefficient of friction is very low about 0.1. It has very good dielectric properties especially at higher radio frequencies. It has a very high bulk resistivity. It is chemically inert. It is also resistant to van der Waals force. It is hydrophobic as well as lipophobic. Creep or ‘Cold Flow’ has been observed in X.
Explain what information is needed to specify a mixer?
At what temperature does water have maximum density?
Explain the reasons of removal of particles from effluent gas?
Can condensate control in a reboiler cause water hammer problems?
What is the maximum recommend pipe velocity for dry and wet gases?
How can you prevent bridging in a dilute phase pneumatic conveying system?
What does the catalytic converter on an automobile do?
What types of valves are recommended for slurry services?
what is R1,R2,R3, R4........?