Interested to Buy Any Domain ? << Click Here >> for more details...
how to check the 3ph capacitor is good or not.
- 14 Answers
- 58959 Views
- MacLellan, Yash Technologies, I also Faced
- E-Mail Answers
Answer Posted / hmt
chrge it for sometime.
and then remove supply and short the terminals, if you see
a spark or here some noise then they are working fine!else
they are not good for use.
| Is This Answer Correct ? | 42 Yes | 36 No |
Post New Answer View All Answers
Draw a SLD of DG distribution up to main LT panel?
How many types of electric motors are there?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
A ii kv 1200 A Breaker combination fixed in a cubicle. How many ampere Fuse is required? If fuse is not using, Why?
What is use of starter and choke in tube light
what is integrated ac contact circuit
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
What happens when ac supply is given as excitation voltage instead of dc supply
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
how to select rating of HT Panel
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
What is the difference between Generator Differential Relay and Transformer Differential Relay?
What is size 00, 01, 1 etc., in HRC fuse types?
