Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between phase current & line
current, how both can be measured in star and delta system
- 9 Answers
- 84591 Views
- Doshion, MIT, I also Faced
- E-Mail Answers
Answer Posted / mani
The phase current is current flow between phase to neutral
is called phase current and the line current is current
flow between two phases is called line current.
In Star winding entire line current passes thru
individual phase i.e. I(ph)=I(L)
In Delta winding however line current gets divided in two
windings. Here I(ph)=I(L)/1.732. Here 1.732 is square root
of 3.
| Is This Answer Correct ? | 138 Yes | 39 No |
Post New Answer View All Answers
What is Delta Connection? What is meant by Forward Delta & Reverse Delta & How Will be the Connection in Power Transformers?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
Circuit diagram of tube light without starter using electrical choke
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
Actuality I have at home electrical panel with 220v 50hz, and I want to converter from there to 110v 60hz, to wiring on the half of my house. Also I like to keep another half of my house with the original 220v 50hz. What is the best and safety way to do?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
Use of switch mode power converter in real-time basis?
work of choke in florocent tube circuit ?
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
what is frequency response?
What is the feedback in the control system?
why we use copper earthing for neutral while for body GI.
Define resonant frequency?
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
