Interested to Buy Any Domain ? << Click Here >> for more details...
In step down transformer (415/200V),mistakenly secondary
side is connected to 415V for some hours, what would be
result of this condition?
- 19 Answers
- 29961 Views
- Essar, GAIL, Vizag Steel, I also Faced
- E-Mail Answers
Answer Posted / girish naik
The transformer secondary is designed for 220V..Its having
lesser turns than 415V side..so if we apply 415V it
experiences overfluxing and damages the insulation losses
and also the temparature..
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
If we want to change a contactor of faulty one what are the conditions want to fullfil
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
What is a dc motor?
What is servo motor? what is its purpose?
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
Why reactors use before incoming of ac vvfd drive?
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
What is Tachometer used to measure?
The inventer is a battery, but if lost current at home u will turn on the fan but the is AC and inventer battery is dc . Then how the fan was rotating. What device Or machine in fan converst the Dc power to Ac power
what is the condition for YnD11
why high speed tripping relay will be used in tripping circuit why not normal relay
How Can you do Maintenance of ACB of 2000Amperes
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
what are the 4 rules to start the motor?
