why study in Michigan tech univ
2- What are the percentages between excitation currents in phase (R, S and T) in ∆ and Ỵ connections in excitation Current test in transformers?
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC.
i m a frsh chemical engineer now i m confuse to attend the interview so anybody pls send model question papers to this christ_vivek33@yahoo.com
why we r not earthed Control cable of C.T. terminals
What are the different power system losses and how can it be eliminated?
Can an inverter be used as a converter? How?
how to make an earthing certificate
Based on the Job Description above, please indicate in details why you are a good match for this position?
what is your aim
What is screw,centrifugal and rotary type compressors,how it works and what is principle .
why do we not use equivalent voltage source in negative sequence equivalent ckt.