Interested to Buy Any Domain ? << Click Here >> for more details...
- Civil Engineering (1773)
- Mechanical Engineering (2114)
- Electrical Engineering (5448)
- Electronics Communications (2383)
- Chemical Engineering (515)
- Aeronautical Engineering (176)
- Bio Engineering (77)
- Metallurgy (300)
- Industrial Engineering (171)
- Instrumentation (934)
- Automobile Engineering (238)
- Mechatronics Engineering (65)
- Marine Engineering (82)
- Power Plant Engineering (36)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (102)
- Engineering AllOther (932)
The output of an AM detector goes directly to the A IF amplifier B Mixer C Audio Amplifier D Loudspeaker
A PLL maintains lock by comparing A The phase of two signals B The frequency of two signals C The amplitude of two signals D None of these
A good op-amp has A Very high bandwidth B Narrow bandwidth C High selectivity D All of these
The loss of precision in quantity is called A Down time B Delay C Unavoidable delay D None of these
The positive clipper can be easily converted into negative clipper by A Reversing diode and changing the polarity of reference voltage B Reversing diode only C Changing the polarity D None of these
....................... regulator operates the power transistors as high frequency on/off switch. A Series B Short C Switching D None of these
How to design a Unit auxiliary transformer for a power house having a unit of 65 MW and Generating voltage of 11 KV and Secondary voltage of 433V
The magnitude of the gain or integrator transfer function using op-amp is A WR1Cf B -1/WR1Cf C -WR1Cf D 1/WR1Cf
If R1=R2, then B=0.5, the total time T of square wave in astable multivibrator using op-amp is A T=RC B T=2 RC ln 3 C T=2 RC ln 2 D T=2RC ln (1+ 0.5)
how to get bearing & winding temperature of an induction motor?
why odd number of lines used for scanning
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
new 90kw motor installed so how I purchased cable ,fuse,etc please give me technic for cable selected why always capacitor delta connection
