Interested to Buy Any Domain ? << Click Here >> for more details...
- Civil Engineering (1773)
- Mechanical Engineering (2114)
- Electrical Engineering (5448)
- Electronics Communications (2383)
- Chemical Engineering (515)
- Aeronautical Engineering (176)
- Bio Engineering (77)
- Metallurgy (300)
- Industrial Engineering (171)
- Instrumentation (934)
- Automobile Engineering (238)
- Mechatronics Engineering (65)
- Marine Engineering (82)
- Power Plant Engineering (36)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (102)
- Engineering AllOther (932)
what is kondo syatem in eletrical traction
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
For hot water : please compare to solar heat and heat pump (environment/operation/invest...) Is there any comparison available. Thank you
why we use 19x9x9and 20x10x10 but not other
What about the year gap criteria for HCL technology?
What is the formulae of Megger value for a A.C.Motor
Sir,I have two years year gapping after the completetion of my 10+2.Then i had studied 1 year chemistry(hons)and had sat for part1 chemistry(Hons) exam..I got 60% in Hons also.I had sat Hons and Enginering Joint entrance exam together in the same year of 2008..But i got better opportunity and I switched to ECE..Sir,may i eligible to sit exams and interviews for any IT company,software technologies,consultancy company,electronics core company..??..thanks...
How is improve my knowledge in construction industries....
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.
about higyway engineering
hi guys ,pls help me......i urgently need previous year question paper for preparation of HPCL (MECHANICAL).pls email me @ mangal_2911@yahoo.co.in
1.what type of the rock is most suitable for wet mix macadam in construction of road? 2.what is the highest maximum dry density and optimum moisture content can be acheive by using most suitable crush rock?
What is Icu and Ics and what is difference b/w them. please tell me how to calculate a size of a copper bar for a system or a breaker... reply on... king.arish@gmail.com would be waiting for a logical answer.
