The following character string is to be transmitted: ABADADAD i. Derive the Huffman and Dynamic Huffman tree codes ii. Determine the savings in transmission bandwidth for both over normal ASCII coding.Write down the actual transmitted bit patterns corresponding to both

ENGINEERING MECHANIC - EXAMPLE 15.3 : A biochemical trolley of mass 15 kg is towing a trailer of mass 5 kg along a straight horizontal pathway. The trailer and the trolley are connected by a light inextensible tow-bar. The engine of the trolley exerts a driving force of magnitude 100 N. The trailer and the trolley experience resistances of magnitude 10 N and 30 N respectively. (a) Form 2 equations with unknowns T and a, that represents the equilibrium for the 2 systems of the trolley and trailer. (b) Solve the simultaneous equations from the 2 equations that are obtained in part (a) of this question. T is the tension of the tow-bar and a is the acceleration.

ENGINEERING DRAWING - EXAMPLE 18.1 : For a Vernier scale of representative fraction (RF) = 1 / 25, calculate the length of the scale for the reading up to 4 metres.

ENGINEERING DRAWING - EXAMPLE 18.2 : For a Vernier scale that consists of 0.11 cm per section, estimate the length on actual standard ruler of 0.1 cm per section for 2.39 m and 0.91 m.

ENGINEERING DRAWING - EXAMPLE 18.3 : Autocad computer program is used to draw a pipe that is used to transport natural gases for processing. Actual length of the pipe is 10 metres. The pipe has cross sectional area of circle in shape with measured circumference of s = 3 metres. (a) If 10 units are used to represent the actual length of the pipe in computerised engineering drawing, find the diameter of the pipe, d that will be shown in the engineering drawing. (b) If one unit in the program equals to 1 centimetre, find the scale used in the computer program.

PROCESS DESIGN - EXAMPLE 21.1 : According to rules of thumb in chemical process design, consider the use of an expander for reducing the pressure of a gas when more than 20 horsepowers can be recovered. The theoretical adiabatic horsepower (THp) for expanding a gas could be estimated from the equation : THp = Q [ Ti / (8130a) ] [ 1 - (Po / Pi) ^ a ] where 3 ^ 3 is 3 power 3 or 27, Q is volumetric flowrate in standard cubic feet per minute, Ti is inlet temperature in degree Rankine, a = (k - 1) / k where k = Cp / Cv, Po and Pi are reference and systemic pressures respectively. (a) Assume Cp / Cv = 1.4, Po = 14.7 psia, (temperature in degree Rankine) = [ (temperature in degree Celsius) + 273.15 ] (9 / 5), nitrogen gas at Pi = 90 psia and 25 degree Celsius flowing at Q = 230 standard cubic feet per minute is to be vented to the atmosphere. According to rules of thumb, should an expander or a valve be used? (b) Find the outlet temperature To by using the equation To = Ti (Po / Pi) ^ a.

ENVIRONMENTAL ENGINEERING - QUESTION 22.3 : A well delivers 225 US-gallons per minute of water to a chemical plant during normal system operation. (a) Calculate its flowrate in the unit of mega US-gallon per day or MGD. (b) The following formula is written next to the chlorine feed point : (chlorine feed rate, lb / day) = (flowrate, MGD) X (dose, mg / L) x (8.34). If this formula is correct, then what should the chlorine feed rate to be in pounds per day (lb / day) if the desired dose is 2 mg / L. (c) Prove by calculations that the constant 8.34 in the formula next to the chlorine feed point is correct. Let 1 US-gallon = 3.78541 L and 1 mg = 0.0000022046 pound.

In a housing society accounting if a defaulter having dues consisting of principal amount and simple interest, pays a part amount whether the received amount should be adjusted first against the interest dues and accordingly reduce the balance principal dues or adjusted only against the principal amount, allowing outstanding simple interest to contineously increase/

FOOD ENGINEERING - QUESTION 23.3 : (a) In the measurement of the browning (optical density) of fruit juice at 10 day interval, the following pairs of data are obtained with time t in days and browning or optical density (OD) : t = 0, OD = 0.05; t = 10, OD = 0.071; t = 20, OD = 0.089; t = 30, OD = 0.11; t = 40, OD = 0.128; t = 50, OD = 0.149; t = 60, OD = 0.17. (i) By using Excel or other programs, determine if such browning reaction can be characterised by pseudo zero order kinetics, with strong correlations between the data pairs of t and OD. (ii) When OD = 0.24, the shelf life T of such juice is expired. Calculate the value of T. (b) Let food cost percentage = ( food cost / food sales ) x 100. If total food cost of bread and butter are $25, food cost percentage of bread is 50 % and for butter is 50 %, find the total food sales of bread and butter.

In advance c form dvat why not showing the amount in form verification

is there any chart showing the suitable cable size according to AMP and length ? for three phase motors

Question 109 - (a) Acceptable wavefunction in quantum mechanics in the range of : negative infinity < x < positive infinity, vanishes at least at one boundary. Which of the following is the wavefunction or are the wavefunctions of acceptable theory : P = x, P = | x |, P = sin x, P = exp (-x), P = exp (-| x |)? State the reason. (b) Let linear momentum operator P = -ih d / dz. The wavefunction is S = exp (-ikz) where i x i = -1, k and h are constants. Find the linear momentum of such wavefunction by using the term P x S.

NATURAL GAS ENGINEERING - QUESTION 26.3 : The United States of America Energy Information Administration reports the following emissions in million metric tons of carbon dioxide in the world for year 2012 : Natural gas : 6799, petroleum : 11695, coal : 13787. Coal-fired electric power generation emits around 2000 pounds of carbon dioxide for every megawatt hour generated, which is almost double the carbon dioxide released by a natural gas-fired electric plant per megawatt hour generated. If 1 metric ton = 1000 kg and 1 pound = 0.4536 kg, estimate the total energy generated by natural gas in the world for year 2012, in gigawatt hour.

GENETIC ENGINEERING - EXAMPLE 27.3 : (a) Male with genotype GGmm and phenotype gray wingless mates with female with genotype ggMM and phenotype black winged in fruit flies. G is dominant to g in color. M is dominant to m in wing shape. If the actual distribution of the second generation of the fruit flies was as follow : 890 gray wingless, 900 black winged, 115 gray winged, 95 black wingless, calculate the recombination frequency between the two genes and distance in recombination units. Let 1 map unit = 1 % recombination. (b) A DNA molecule has 180 base pairs and 20 % adenine. How many cytosine nucleotides are present in this molecule of DNA?

BIOCHEMICAL ENGINEERING INSTRUMENTATION - EXAMPLE 29.2 : (a) In order to determine the slurry volume (L) in chromatography, arrange the formula using the following parameters : slurry concentration (%), slurry volume (L), settled chromatography medium volume (L), 100. (b) In order to determine the chromatography medium volume (L) in gel filtration chromatography, arrange the formula using the following parameters : sample volume to be processed (L), chromatography medium volume (L), sample volume in percent of total column volume (%), 100.