Which of the following are characteristics of UDP? A.) UDP is connection oriented. B.) UDP is used with TFTP. C.) UDP is unreliable. D.) UDP is connectionless. E.) UDP is at the transport layer. F.) UDP uses no acknowledgements.

Which of the following are examples of the Transport Layer? A.) Token Ring B.) UDP C.) TCP D.) IP E.) SQL F.) LLC

Which of the following describe SMTP? A.) Used for downloading files to the router. B.) Used for sending e-mail. C.) Uses TCP. D.) Uses UDP. E.) Uses port 25. F.) Used for managing IP devices.

Which of the following are Transport layer protocols? A.) UDP B.) TCP C.) NBP D.) IP E.) SPX

Which of the following are examples of the Session Layer? A.) TCP B.) RPC C.) SQL D.) NFS E.) Token Ring

Which of the following is true? A. The default is to send debug output to the console screen. B. To view debug output from a telnet session, the "terminal monitor" command must be used C. If the "logging buffered" command is used, the debug output would be sent to RAM and can be viewed with the "show log" command D. If the "no console loggin" command were configured, output would besent to a telnet session E. All of the above F. None of the above G. A, B, and C. H. A, C, D, and E.

Which of the following is True regarding passwords on a Cisco router? A. All passwords can be encrypted B. All passwords can be entered using the set-up dialogue C. A password can be set before a user can enter the privileged mode D. A password can be set for individual lines E. TACACS or Radius password authentication can be used.

TATA,

Which of the follwing are true of standard half-duplex Ethernet circuitry? A. It is alternate one-way communication B. The receive (RX) is wired directly to the transmit (TX) of the remote station C. The transmit (TX) is wired directly to the receive (RX) of the remote station D. Collisions are not possible E. Both stations can transmit simultaneously

Given the following descriptions of layers of the OSI model 1) This layer segments and reassembles data into a data stream 2) This layer manages device addressing tracks the location of devices on the network and determines the best way to move data 3) This layer provides the physical transmission of the data and handles error notification network topology and flow control. Choose the statement that lists the layers in the order described above A. physical data link network B. physical session data link C. data link network transport D. data link transport network E. transport network data link F. transport data link network

Given the following IP address from the Class B address range 172.35.21.12. Your network plan requires no more than 126 hosts on a shored. Which value should you use as the subnet mask? A. 255.255.0.0 B. 255.255.128.0 C. 255.255.126.0 D. 255.255.255.128 E. 255.255.255.252

Given the following IP address from the Class C address range 192.168.21.12. Your network plan needs addresses for 28 small prkps Each office uses its own shored. The network design specifies that you confound for five bits of subnetting. When you confound for this in Cisco IOS software which shored mask should you use? A. 255.255.0.28 B. 255.255.255.0 C. 255.255.255.28 D. 255.255.255.248 E. 255.255.255.252

You just entered the following command_Router(config#) line console 0 Which operation is most likely to follow? A. Confound terminal type B. enter protocol parameters for a serial line C. create a password on the console terminal line D. establish a terminal type 4 connection to a remote host E. change from configuration mode to console privileged mode

Intel, Quark, Wipro,

What is wrong with the following code: <%afname="header.asp"%>"?>

Which of the following are true regarding switched virtual circuits (SVCs) and permanent virtual circuits (PVCs)? Choose two. A. SVCs and PVCs can use the same circuit. B. PVCs are permanently established virtual circuits. C. SVCs and PVCs terminate the circuit when data transmission is complete. D. SVCs are virtual circuits that are dynamically established on demand and terminated when data transmission is complete.

Which two of the following describe ASN.1 (Abstract Syntax Notation One)? A. It is an abstract routing protocol that is not used very often. B. It is an OSI language for describing data types independent of particular computer structures and representation techniques. C. Consists of only one basic routing algorithm. D. Uses BER (Basic Encoding Rules).